We're here to help

 Installation Tutorial:

1.  Set the voltage and timer switches.
   • Refer to the Cut-off Voltage Settings below and set the switches according to your requirements.
2. Connect the red ACC(+) wire to a Switched fuse.
   • Referring to your vehicle Owner's Manual / Handbook, identify a Switched (accessory power) fuse in your interior fuse panel. Typical examples are the cigarette lighter and car stereo fuse slots.
   • Remove the identified Switched fuse. Many cars come with a fuse puller tool in the engine compartment fuse panel.
   • Remove the sleeve from the end of the red ACC(+) wire, and wrap the wire around one of the blades of the Switched fuse. Reinsert the fuse back into the fuse panel.
3. Connect the yellow BATT(+) wire to a Constant Power fuse.
   • Identify a Constant Power (battery power) fuse in your fuse panel. Typical Constant Power fused are the hard light (emergency lamp), tail lights, and interior light fuses. If your car has a "Battery Saver Function" please utilize the hazard light fuse.
   • Remove the identified Constant Power fuse. Remove the sleeve from the end of the yellow BATT(+) wire, and wrap the wire around one of the blades of the Constant Power fuse. Reinsert the fuse back into the fuse panel.
4. Connect the black GND wire to a ground point.
   • Locate a ground point. such as a bolt, that is directly on a bare metal part of the vehicle's frame. Secure the ground wire to the bare metal frame (for example by securing it under the bolt).
5. Plug your dashcam's power plug into the cigarette lighter socket on the wire harness.
   • To ensure good electrical contact you can use electrical tape to tape the plug and socket together.
6. Plug the wire harness into the Power Magic Pro
   • Plug the wire harness in and check that the Parking Mode Switch turns the LED on/off. Start your engine and check that the dashcam is powered when the Parking Mode Switch is both ON and OFF.
7. Fix the Power Magic Pro in place
   • Secure any excess wire and fix your Power Magic Pro in place using the supplied double-sided tape and/or screws.

Product Settings:

*You can download the detailed product manual from our website.