no, your video was not in detail. The video shows a nissan murano 2015 like mine, it shows being hit in a parking lot like mine, I checked the video and nothing was recorded, last recording was when I parked as time stamp shows, so it only works when car is on, but once I close the door and lock the car, all ends. I searched everywhere and cant find why. I was told to call CCTV and they are puzzled, no one has called or maybe no one plugged into a nissan. I think the issue is the software on the cameras that wont let it power up, because I no longer can use the app on my phone, it wont connect to the camera. I pull the card and checked on my laptop. I purchased a Power Magic Pro, and have the same issue, will not work in park mode. I purchased a new camera 750 and same with that camera, not buying the 950 yet, way to expensive, other companies have identical look camera like yours at Best Buy and cheaper for a 4K. Maybe Pittasoft or Blackvue no longer cares about products, I dont know what to do, spent amost $800 for 2 cameras, SD cards, power pro and EZ nothing works. does not work on either car
If this is not approved due that I write the truth, the I will post this screenshot on facebook, and all sites related to this product, I just cant get real help
Warning. This product does not work. Even with the voltage cut off set at 12.5V, the camera will drain the battery to the point the car cannot be started. This occurred in a brand new car with a brand new battery. Also, the Parking mode on/off switch fails to turn the camera off when the car is parked.
I have the same problem. This feature killed my car's battery.
I setup voltage cut off at 12.5V, the camera drained the battery to the point the car cannot be started. Parking mode on/off switch fails to turn the camera off when the car is parked. Which settings ate the most battery power saving?
Hello! The blackvue Power Magic EZ device for the 2-channel blackvue DR470-2CH DVR, purchased in the same company earlier, was purchased from the official distributor. The car Subaru Forester SJ 2018,there is no additional alarm - only a regular immobilizer, no additional electronics, the head unit is standard. In Parking mode ON at the set off voltage of 12.5 V for 2 weeks discharged the battery to 2.4 V, which before (and now when disconnected from the OBD connector of your device) is not observed. When translated in Parking mode OFF, the DVR continues to work. Also, when power Magic EZ is connected, I can not open the front right window from the driver's door - the other 3 open, directly from the front passenger's door without problems. When you disconnect your device, everything works correctly. How to be? Your uses 4 pins in connector 5 and 6 - minus, 16 - +12V, why use 14 pin CAN-Low?