Troubleshooting a "no power" condition

Paul Wilson

• April 04, 2017 21:56

I completed running all of the wiring for my cam's today and was disappointed that I had no power indication when I turned on my Power Magic Pro.

With the ignition off I verified that I had power to the yellow pin on the connector that plugs into the module and no power to the red pin.

Is there someone who can offer a suggestion? I have contacted Amazon who will be sending me a replacement but I want to be sure I have done the installation right.

I used "add a fuse" for both the red and yellow wires. Not sure what else I could look for at this point.

0

• 

  walrenshi

  • April 09, 2017 12:21

  Hi Paul,

  yesterday I have installed a dr650s also with Magic Pro. As I was working several ours with Radio on, the Voltage of the carbattery was 11,92V After driving a bit its working Fine. So check the Voltage on the yellow wire when the engine if off.

  Regards

  Walter

  0
• 

  walrenshi

  • April 09, 2017 12:31

  Hi Paul,

  yesterday I have installed a dr650s also with Magic Pro. As I was working several ours with Radio on, the Voltage of the carbattery was 11,92V After driving a bit its working Fine. So check the Voltage on the yellow wire when the engine is off.

  Regards

  Walter

  0

Please sign in to leave a comment.